Picture of base for Rip's power rack

[Drewcar]

My friend is fabricating a power rack for me as per Rip's spec. He's looking for a little more guidance for how to fabricate the base of the rack. Does anybody have a picture of the base before the plywood is installed? Also, since the depth of the steel channel is approximately 1.6", what's the best way to achieve the desired height off the floor so that it is flush with the platform?

[hatmanii]

Well, you can either just carve out footprints in the platform and then bolt it.... or just bolt it straight to the platform.

As far as the feet themselves, I would assume just some basic footplates with holes drilled that allow for bolting.

-Hat